1. The removal order of the bamboo plywood should be the first branch and then the first branch, the first non-load-bearing template, and then the load-bearing template.
2. When removing the large-span bamboo plywood, it should be carried out from the middle to the two ends.
3. When removing the bearing template, it must be controlled by strength, requiring a group of test blocks to be made on site and maintained under the same conditions as the component, as the basis for the strength of the mold removal; If the non-load-bearing formwork is removed, the strength of the concrete must be greater than 1.2MPa, so that the surface and corners of the concrete will not be damaged when the mold is removed.
4. The removal of bamboo rubber plate can not be too hard, the removal of the template, fasteners, accessories should be carried away in time, the removal of the steel mold should be passed down piece by piece, can not be thrown directly.
